国产无人区卡一卡二卡三乱码99 I 日韩欧美一区在线 I 青草草在线视频免费观看 I 成人国产亚洲 I 欧美a v在线 I 成人无码嫩草影院 I 亚洲欧美综合国产精品二区 I 亚洲国产三区 I 第一色网站 I 国产精品亚洲а∨天堂免 I 国产日产欧产精品精品软件 I 草久在线观看 I 久艹久久 I www.一级片 I 91丨九色丨高潮丰满 I 91首页 I 色播五月综合网 I 亚洲一区二区视频在线 I 超碰在线综合 I 欧美,日韩,国产在线 I 欧美色欲色欲xxxxx I 亚洲免费91 I 欧美v在 I 亚洲另类一二三区 I 国产性猛交xxxx免费看久久 I 久久狼人天堂 I 青青草国产在线 I 国产初高中生真实在线视频 I av蜜臀在线 I 鲁一鲁一鲁一鲁一色

Key technology of grinding machine and its measures

1. The main surface is an inner cylindrical surface, with high dimensional tolerance grade and small surface roughness Ra value of 1.

Measures taken: divide the processing stages, and adopt the process route: drilling-rough boring (expanding)-semi-finish boring (reaming)-rough grinding-fine grinding-grinding; Select precision machine tools; Control cutting parameters; Cool thoroughly.

2. Because of the high dimensional tolerance of the outer cylindrical surface, the surface roughness Ra is small.

Therefore, the measures taken are as follows: the requirements for the division of machining stages, the selection of machine tools and the control of cutting parameters are the same as those for inner cylindrical surface machining. In addition, the process route is: rough turning-semi-finish turning-rough grinding-fine grinding.

3. The outer cylinder 45r6 requires high radial runout of the inner hole 32H7.

One of the measures taken: positioning and clamping with non-matching outer cylindrical surface, grinding the inner hole with one clamping? 32H7, outer cylinder? 45r6, that is, the method of "one knife". However, this method has frequent adjustment of machine tools, long auxiliary time and low production efficiency, and is only suitable for single piece production.

The second measure: the inner cylindrical surface is limited by the taper mandrel, and the outer cylindrical surface is grinded with the center holes at both ends of the mandrel. This method is easy to operate, high in production efficiency, stable and reliable in quality, but it needs to manufacture special machine tool fixtures, so it is suitable for batch production.

Mechanical processing sequence arrangement

Turning end face-turning excircle-drilling-boring-grinding. Among them, the finish machining of the inner hole should be carried out before the finish machining of the outer surface.

Division of processing stages

The whole machining process is divided into four stages: rough machining, semi-finish machining, heat treatment and finish machining.